We Have Lights But No Power

The most likely reason for your power points not working when your lights are ok is that your safety switch has tripped.

We have lights but no power.

Electronic models have a child lock out feature to prevent the dishwasher from accidentally being turned on. He s also tested to make sure there was power coming to the bulb socket and sure enough there is. Make sure the power switch is connected to the motherboard if you re using a desktop. Now to check if this is the real problem go to your switch board and check out your safety switch.

A loose wire connection can cause the wire to overheat eventually causing the connection to fail. We ve run extension cords for power before but it would be cool if any of the offbeat homies have got better ideas for lighting up the balcony. Of course we tried changing out the bulb but no light. We d love to make more use of our large balcony except there s no power outlet out there or even lights above.

It gets pretty dark out there so we havent really made much use of the space at night which is a shame. Checked the elec box and there are all separate switches one is for the lights turned it off and on again but no luck. No power to outlets flickering lights or an intermittent loss of power are usually attributed to a loose wire connection if the circuit breakers are working properly. We d very much appreciate any insights leads.

If the fixture works properly. So what could be causing the problem. Power to the fixture but no light. If this resolves the problem then have the appliance in question checked by electricians plus.

Woke up this morning and none of the lights in the house are working power points are fine though. Sometimes a loose connection will make a crackling noise. This is not a very common point of failure but your pc might not be turning on because the power button isn t properly connected to the motherboard. Check the control lock feature control lock feature.

I bet you tested for power to the ground. If it doesn t work but you have power the neutral may be the problem as suggested. Our other porch light is downstream on the same circuit and is working fine. Most case switches are connected to the motherboard via a red and black twisted pair of wires.

Unplug and remove from the power point simply switching off the power point will not work the last electrical appliance that you were using and try to reset the safety switch. The light fixture does not use the ground to power the lights. It uses the neutral. If so that tells you that the switch is still the issue.