Till panel welded in.
Welding floor pans with flux core.
The flux core wire seemed to spatter more.
Single spot weld move etc.
Ford truck cab floor panel lh 27.
December 15 2017 01 05 00 pm ok thanks planning on using 030 wire its a goplus 130 welder.
Im a novice welder.
The wait is finally over the quarter panels are welded onto the civic and the civic rust is no more.
After tacking the new floor pans it was a bear to clean the old metal.
I went after the welding with just light wire wheeling.
My one suggestion i can pass on make sure the old metal is clean.
I am sealing off the inside of the car with a self etc.
Settings to weld floor pans with flux core reply 4 on.
I have used gasless flux core to do 20 gauge floors up to 24 gauge quarter panels.
I just did this on my jeep.
I have the the 024 wire and c25 also it is higher quality but when just doing spots the flux core was acceptable if set up properly.